|
Rug
scrubbing is fine at times. However, too
much of something is bad enough. To get
rid of those stubborn stains on your
carpet, first remove all the heavy
furniture from your rug and run the
vacuum cleaner both ways on the floor to
insure all dust or loose dirt is gone
before using the cleaning equipment.
Spray detergent lightly over heavy
traffic areas to help loosen ground in
dirt and pre-treat any areas with a
heavy concentration of dirt or on
stains.
A good carpet cleaning tip is to
pre-treat heavily stained areas with a
detergent before any equipment is turned
on. Most of the floors cleaning devices
use water to dispense the detergents
onto the rug. Profoundly, steam cleaners
will use most water on the carpet.
Another simple carpet cleaning tip is
that you should start in one corner and
slowly work your way over the entire
surface of the carpet, using only as
much water as required for dampening the
carpet.
You should turn 90 degrees and go over
the carpet a second time when you are
finished with the entire floor. If still
some stains remains there, you need to
do it again on that area. Use the vacuum
part of the equipment to pick up as much
moisture out of the rug as possible,
once you are satisfied with the way the
carpeting looks. Once your carpet is
dry, only then put the furniture back
into the place from where it was moved. |
